Bryan,
I finally got around to installing a computer pressure
transducer/transmitter onto the Phoenix I got last summer. But I ran into a
problem. Unfortunately, I find that all of the ports tapped into the
Phoenix are threaded for low pressue hoses. None are large enough for
high-pressure connectors. Now, am I missing something here? If not, then
this is somewhat disturbing. First, that this mistake could occur in the
first place and second, that a quality check didn't catch it, especially
when installing the plugs. So no one would intentionally install a low
pressure hose into a high-pressure port, but mistakes can happen and in this
case, the hose would install just as if it were in the correct port. Let me
know if I'm crazy here, or not, and then what we should do next.
Thanks,
XXXXXX