So this is the test camera. The spanner lever is blocked so the camera does not work.
The first thing I removed is the cover of the electronics and mechanical parts.
you can see the internals.
the rewind lever and asa control assembly is hold in place with a clip. after removing this the assembly comes out.
the spanner lever assembly is hold in place with a single screw. The battery has to come out. The camera itself is held in place with
three smal screws. after removing these the interns comes out of the casing. You have to disconnect the connection to the view lens and
desolder the flash connector wires.
the camera itself. as you can see it has water dammage and corrosion.
the empty case.
the rewind/asa knob assembly. you can see the clip
everything layed out.
Now I have to look for O-rings. I have been reading about this and learned there is a Japanese O-ring normalisaton system.
wil have to do some mesuring and looking up.