Can I get some advice I have how to clean my parts
I did some cleaning with simple green and warm water with a brass brush
TylerAronson wrote: ↑Sun May 06, 2018 12:02 pmDo I need to have my pieces re-chromed or will they be fine as is?
I have only re-chromed for cosmetic reasons. As long as you wash and dry your parts after each dive trip I personally don't see a need to re-chrome. Others may have different views.
Also, I accidentally broke the faceplate tabs is there a way to Glue it to the can or any way to get it to stay on the can?
I always add a drop of silicone to the back of the name plate but that is just to keep it from sliding around too much even with the tabs. Without the tabs I'm not sure silicone sealant would be enough. I think 3M makes a double-sided adhesive tape that some folks have used for the round label HW and early 70's USD round labels. I forget the name. Otherwise, just order a new repro label from Allan. His are great. Can't tell the difference from the original. Good luck. Mark.
Return to “New Vintage Equipment Diver's Forum”
Users browsing this forum: No registered users and 1 guest