Moderators: simonbeans, captain
No answer for those questions, sorryWhen were these available, were they only availble on models with a certain address?
Standard mouthpiece valves will fit but you will need to enlarge the holes on the wagon wheels a bit and trim the stem to get it to pass though. A small drop of silicone to hold it in place and you are good to go. Mine have been this way for 10+ years with no issue.Fibonacci wrote: Put me on the list if VDH gets around to making reproduction Aquastop mouthpieces
It would cost twice as much to reproduce the LaSpirotechnique mouthpiece than it did to make the Argonaut DSV
However the inlet/exhaust non-return valves are completely shot... they are 31mm dia but I don't see that size listed in the VDH store.
G250 valves at 33mm dia are too big.
Will the Kraken DSV/Duckbill Eliminator valves fit... their actual diameter is not listed?
No I mean mouthpiece valves. The DBE and Kraken exhaust are a larger diameter and won't work.Fibonacci wrote:Thanks Bryan... by standard mouthpiece valves you mean the ones on the Kraken and DBE?
Return to “Classic Vintage Diving”
Users browsing this forum: No registered users and 69 guests