Page 1 of 1
Atomic questions
Posted: Sun May 20, 2018 6:06 pm
by ScubaLawyer
Having zero fear of any regulator at this point
, I decided to overhaul an Atomic Aquatics reg (post 2003 brass 1st stage). I don't want to buy all the specialty tools for my one-off project so I'm winging it. The first (I assume of many) issue encountered is that the indentations on the swivel cap are too shallow for my pin spanner. Suggestions on how to remove? Thanks, Mark.
AA1.jpg
Re: Atomic questions
Posted: Sun May 20, 2018 7:58 pm
by rhwestfall
pins are cheap, grind it to make it work, buy more pins for other regs....
Re: Atomic questions
Posted: Sun May 20, 2018 8:39 pm
by Bryan
You can also use a cheap pipe strap wrench. Your local hardware store will have them but Harbour freight will have them the cheapest and for this purpose it should work fine.
https://www.harborfreight.com/2-pc-rubb ... 69373.html
Re: Atomic questions
Posted: Mon May 21, 2018 8:53 am
by lexvil
I use a scubapro combo tool
Re: Atomic questions
Posted: Mon May 21, 2018 9:25 am
by ScubaLawyer
All good ideas! Thanks. Mark